Click to read an update for Barudan D Series machine support (4/8/21)

 

Please save the system software zip file below to your hard drive, and then to either a blank 3.5" high density floppy disk or CompactFlash card.

If you are updating the software due to CF card issues or compatibility, please see CF Card Rules for details.

Label the disk:

DS/DY System Disk
Version [####]

To load this software from floppy:

1. Turn the power OFF at the Automat.
2. Insert the floppy disk with the new system software on it.
3. Press and hold the Read key, while powering ON (on the Automat) until you see the "System Version" Screen.
4. Press the Read key to start the update process. Update takes a few minutes.
5. After the update completes, seek origin as you normally would upon power-on.

To load this software from CF card:

1. Unzip the system software file.
2. Create a new folder on the CF card named SYSTEM.
3. Save the system software file (*.sys) to the SYSTEM folder you just created.
4. Turn the power OFF at the Automat.
5. Insert the CF card with the new system software on it.
6. Press and hold the Read key, while powering ON (on the Automat) until you see the "System Version" Screen.
7. Press and hold the Memory key to read the system files.
8. Select the correct system file to load by using the Jog keys, press and hold the Execute key for 5 seconds to start the update process.
9. After the update completes, seek origin as you normally would upon power-on.

 

Please save the system software zip file below to your hard drive, and then to either a blank 3.5" high density floppy disk or CompactFlash card. 

Label the disk:

DT System Disk
Version [####]

1.      Unzip the system file.
2.      Create a new folder on the CF card named SYSTEM. 
3.      Save the system software file (*.sys) to the SYSTEM folder you just created. 
4.      Turn the power OFF at the Automat. 
5.      Insert the CF card with the new system software on it. 
6.      Press and hold the Start key, while powering ON (on the Automat) until you see the "System Version" Screen. 
7.      Select the correct system file to load by using the Jog keys, then press and hold the Execute key for 5 seconds to start the update process. 
8.      After the update completes, seek origin as you normally would upon power-on.

Software should update automatically and may take a few minutes to complete. Once it stops and the seek origin screen appears, the machine is ready to go.