Barudan Home :: Support :: Software Downloads :: N Series Updates

N Series Updates

Instructions for installing N series machine software

Please save the system software file (*.zip) below to your hard drive. Unzip the system software file. Save the system software file (*.sys) to a blank 3.5" high density floppy disk. 
Write down the machine parameters before beginning this installation, and delete all designs stored in the machine's memory.

Label the Disk: NS/NY System Disk Version XXXX

To load this software from floppy:

  1. Turn the power OFF at the Automat.
  2. Insert the floppy disk with the new system software on it.
  3. Press and hold the Read key, while powering ON (on the Automat) until you see the "System Version" Screen.
  4. Press the Read key to start the update process. Update takes a few minutes.

After the update completes, seek origin as you normally would upon power-on.

NS/NY Software

This software is for Barudan models with the NS or NY Automat controllers. These have a model number with "NY" or "NS" as the 3rd & 4th letters. Specific model numbers include:

  • BENYHE-ZQ-C02, BENYHE-ZQ-C04, BENYHE-ZQ-C06, BENYHE-ZQ-C08
  • BENYH-YN-C12
  • BENSME-ZQ-A12, BENSME-ZQ-A15
     

Current Release V3.70 R03 (dated 11/2007)
Call Technical Support for Download file 866-825-5884.

NOTE- This software requires Boot ROM version 4.0 or higher

  • The Boot ROM version is shown on the bottom of the display in the Software Update Screen
  • Failure to have Boot ROM Version 4.00 or higher, will cause the Software Install to crash at about 99%, and give a continuous beep from the Automat. If this happens, you need to re-install an older version of software to clear the problem
  • Unfortunately newer Boot ROMs are no longer available for purchase

BENT Software

This software is for Barudan Elite machine. Model numbers include:

  • BENT-ZN-101
  • BENT-ZQ-201

Please save the system software zip file below to your hard drive. Unzip the system software file. Save the system software file(*.sys) to a blank 3.5" high density floppy disk. Write down the machine parameters before beginning this installation, and delete all designs stored in the machine's memory.

Label the Disk: BENT System Disk Version XXXX

To load this software from floppy:

  1. Turn the power OFF at the Automat.
  2. Insert the floppy disk with the new system software on it.
  3. Press and hold the Start key, while powering ON (on the Automat) until you see the "System Version" Screen.
  4. Press the Start key to start the update process. Update takes a few minutes.
  5. After the update completes, seek origin as you normally would upon power-on.

Current Release V2.50 R01  (posted 11//2007)
Call Technical Support for Download file 866-825-5884.